OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P01A3

Alternative Fuel Rail Pressure Sensor Circuit

These codes only apply to vehicles that run on a gaseous alternative fuel – compressed natural gas (CNG) or LPG – either as bi-fuel models alongside petrol (for example GM's 2015–2016 Impala Bi-Fuel or 2013–2016 Silverado/Sierra 2500HD) or as dedicated gas engines. CNG is stored at up to about 250 bar (3600 psi); a regulator reduces it to a few bar for the gas rail and injectors. The gas rail pressure sensor measures the regulated low pressure at the rail – on GM's Impala controlled by the engine module to 68–130 psi (about 4.7–9 bar) – so that injection time can be matched to the actual gas pressure and density. P01A3 is the general circuit fault of this sensor. Without a valid rail pressure the module cannot dose gas correctly; Ford's earlier bi-fuel system started on gas only above about 5.2 bar and otherwise stayed on petrol. Typical reaction: gas operation is blocked and a bi-fuel vehicle switches to petrol. No manufacturer document naming exactly this code was found; GM's bulletins only state that faults are reported like on petrol models. The description rests on CARB, which treats such vehicles like petrol engines for model years 2004–2018, and on the documented system design.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number1 / A3

Possible causes

  • Connector or wiring at the rail pressure sensor damaged by heat or corroded high
  • Gas rail pressure sensor faulty medium
  • 5 V reference or ground disturbed medium
  • Control module faulty low

Symptoms

  • Check engine light on
  • Switch to petrol or gas operation not selectable
  • Hesitation, loss of power or mixture faults in gas mode
  • Dedicated gas engines: limp mode or starting problems

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P01A3

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication