OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P01A0

Alternative Fuel Tank A Pressure Sensor Circuit Low

These codes only apply to vehicles that run on a gaseous alternative fuel – compressed natural gas (CNG) or LPG – either as bi-fuel models alongside petrol (for example GM's 2015–2016 Impala Bi-Fuel or 2013–2016 Silverado/Sierra 2500HD) or as dedicated gas engines. CNG is stored at up to about 250 bar (3600 psi); a regulator reduces it to a few bar for the gas rail and injectors. The tank pressure sensor A sits at or in the regulator; together with the tank temperature it gives the gas level, and it decides whether gas operation is possible. P01A0 means the signal voltage is below its lower limit – typically a signal wire shorted to ground or open, or a missing 5 V reference. Typical reaction: gas operation is blocked and a bi-fuel vehicle switches to petrol. No manufacturer document naming exactly this code was found; GM's bulletins only state that faults are reported like on petrol models. The description rests on CARB, which treats such vehicles like petrol engines for model years 2004–2018, and on the documented system design.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number1 / A0

Possible causes

  • Signal wire shorted to ground or open high
  • 5 V reference missing (open, or short in the shared 5 V circuit) medium
  • Tank pressure sensor faulty internally medium
  • Connector at the regulator corroded medium

Symptoms

  • Check engine light on
  • Gas level gauge wrong, jumping or showing empty
  • Gas operation blocked or automatic switch to petrol
  • Dedicated gas engines: limp mode or starting problems possible

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P01A0

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication