OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P019B

O2 Sensor Delayed Response - Lean to Rich Bank 1 Sensor 3

Sensor 3 on bank 1 is a switching oxygen sensor behind a second converter or converter brick; it exists on Jaguar Land Rover's supercharged V6 and V8 (on both banks) and on Ford systems that monitor part of the converter volume. 'Delayed response' means the sensor starts reacting too late after a mixture change – unlike 'slow response' (P0145/P0165), where the transition itself is too flat. This code covers the lean-to-rich direction, tested when the module enriches the mixture after overrun. For sensor 2, GM checks whether the signal rises above 350 mV before a calibrated air mass has passed; behind two converters their oxygen storage buffers the change, so limits are wide. No manufacturer document using exactly this code was found – the Jaguar Land Rover bulletins list only P0142ff/P0162ff for sensor 3 – so the description rests on CARB's response requirement and the sensor 2 logic. There is no limp mode; the converter monitor cannot complete.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number1 / 9B

Possible causes

  • Sensor 3 aged, sooted or oil-poisoned high
  • Exhaust leak ahead of sensor 3 medium
  • Converter with strongly differing oxygen storage (aftermarket or new) low
  • Sensor 3 heater weak low
  • Control module software low

Symptoms

  • Check engine light on
  • No noticeable change in driving
  • Catalyst readiness not set (emissions test)

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for P019B

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication