OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0198

Engine Oil Temperature Sensor A Circuit High

The engine oil temperature sensor A is an NTC thermistor fed with 5 V through a resistor: the hotter the oil, the lower the signal voltage. The engine module uses the oil temperature for variable cam timing (Ford disables it with cold oil or a sensor fault), engine protection and the oil life monitor; many engines have no such sensor and use a calculated oil temperature instead. P0198 means the signal sits near the 5 V reference, so the module sees extremely cold oil (below −40 °C) – typically an unplugged connector, a broken wire, an open sensor element or a short to voltage. Ford sets it above 4.93–4.96 V for 5 s; GM above 450 kΩ, enabled only after 20 s of running or above −20 °C coolant so that real extreme cold is not mistaken for a fault; no MIL on the 2018 LT4, two trips in 2019. The module uses a substitute value and Ford disables variable cam timing.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number1 / 98

Possible causes

  • Connector unplugged or pins corroded, signal or ground wire broken high
  • Sensor element open medium
  • Signal wire shorted to 5 V or battery voltage low
  • Control module pull-up or input faulty low

Symptoms

  • Check engine light on (depending on manufacturer)
  • Oil temperature display stays at minimum or blank
  • Restricted cam timing, possibly slightly less power
  • Oil life monitor calculates with a substitute value

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for P0198

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication