OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0196

Engine Oil Temperature Sensor A Range/Performance

The engine oil temperature sensor A is an NTC thermistor fed with 5 V through a resistor: the hotter the oil, the lower the signal voltage. The engine module uses the oil temperature for variable cam timing (Ford disables it with cold oil or a sensor fault), engine protection and the oil life monitor; many engines have no such sensor and use a calculated oil temperature instead. P0196 means the signal is electrically valid but implausible – stuck, offset or rising wrongly. GM's LT4 runs three tests: after a cold soak oil, coolant and intake air must agree within 16 °C; during warm-up the oil must reach 90 °C after enough air mass; and continuously it is compared with a model (fault above 30 °C); two trips. Saab expects at least 50 °C once coolant has held 80 °C for 3 min. Caution: on Ford's 2023 diesels P0196 actually checks the coolant sensor against oil temperature (35 °C after 6 h), and Nissan traced it on the Rogue to a faulty coolant control valve.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number1 / 96

Possible causes

  • Oil temperature sensor drifting or stuck (offset) high
  • Comparison sensor (coolant, intake air) or its wiring wrong medium
  • Thermal management or coolant control valve, or thermostat faulty (oil genuinely too hot or cold) medium
  • Contact resistance in the connector medium
  • Control module software low

Symptoms

  • Check engine light on (usually after two drives)
  • Implausible oil temperature reading
  • Possibly a cam timing code alongside
  • Often no noticeable symptoms

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0196

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication