OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0195

Engine Oil Temperature Sensor A Circuit

The engine oil temperature sensor A is an NTC thermistor fed with 5 V through a resistor: the hotter the oil, the lower the signal voltage. The engine module uses the oil temperature for variable cam timing (Ford disables it with cold oil or a sensor fault), engine protection and the oil life monitor; many engines have no such sensor and use a calculated oil temperature instead. P0195 is the general circuit fault without telling low from high. With analogue sensors most manufacturers use P0197/P0198 instead. The documented use is Ford's 2023 diesels with a digital SENT oil temperature sensor: P0195 is set when the sensor reports a status or data fault for 5 s, while a complete loss of communication is U0667. The module then uses a substitute value (Saab: 100 °C), and functions relying on oil temperature are restricted.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number1 / 95

Possible causes

  • Connector or harness damaged, corroded or oil-soaked high
  • Sensor faulty internally (electronics fault on SENT sensors) medium
  • 5 V reference or ground problem in the sensor circuit medium
  • Control module or software low

Symptoms

  • Check engine light on (depending on manufacturer)
  • Oil temperature display missing or fixed
  • Restricted cam timing, slightly reduced power
  • Oil life calculation less accurate

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for P0195

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication