P0194
Fuel Rail Pressure Sensor A Circuit Intermittent/Erratic
The rail pressure sensor A measures the pressure in the high-pressure fuel rail of common-rail diesels and petrol direct-injection engines; it is either a three-wire sensor (5 V reference, ground, signal rising with pressure, about 0.5 V at 0 bar) or a digital SENT sensor with two measuring channels. The engine module uses it as the feedback signal for rail pressure control. P0194 detects jumps or dropouts: the signal changes faster than rail pressure physically can. GM's 2016 diesels set it when two consecutive samples 6.25 ms apart differ by more than 15 MPa (80 of 115 samples) and store it without lighting the MIL; Saab uses two trips, Volvo and Mack light the MIL. Volvo/Mack bulletins trace it to corroded or worn contacts at sensor and harness, often together with P016E because the pressure control reacts to the jumping signal; the fix was a new sensor and harness section.
Possible causes
- Corrosion or wear at sensor and harness contacts high
- Harness chafed or loose contact medium
- Rail pressure sensor faulty internally medium
- Ground problem or control module low
Symptoms
- Check engine light on (not on GM 2016 diesels)
- Brief stumbling or misfire-like dropouts
- Occasional limp mode, fault often not reproducible
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P0194
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- law.cornell.edu/regulations/california/13-CCR-1968.2
- gsi.ext.gm.com/gmspo/mode6/pdf/2016/16OBDG04 Engine Diagnostics.pdf
- static.nhtsa.gov/odi/tsbs/2018/MC-10152578-9999.pdf
- static.nhtsa.gov/odi/tsbs/2020/MC-10185304-0001.pdf
- saabwisonline.com/9-5-9650/2011/2-engine/engine-management-and-fuel-system-4-cyl-diesel/fault-diagnosis-diagnostic-trouble-codes/dtc-p0192-or-p0193