OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0192

Fuel Rail Pressure Sensor A Circuit Low

The rail pressure sensor A measures the pressure in the high-pressure fuel rail of common-rail diesels and petrol direct-injection engines; it is either a three-wire sensor (5 V reference, ground, signal rising with pressure, about 0.5 V at 0 bar) or a digital SENT sensor with two measuring channels. The engine module uses it as the feedback signal for rail pressure control. P0192 means the signal is below the physically possible range – typically a signal wire shorted to ground or an open 5 V reference. Limits: Ford diesel below 0.13 V for 0.5 s, Ford petrol direct injection below 0.20 V for 5 s, GM diesel below 4.3 % of supply, GM 6.6 litre below 0.19 V, Saab/GM 2.0 diesel below 0.25 V. Monitored continuously; GM one trip, Saab two. If several sensors report low voltage at once, the shared 5 V reference is the likely cause. On a fault the module uses a substitute value and usually limits power.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number1 / 92

Possible causes

  • Signal wire shorted to ground, harness chafed high
  • 5 V reference open or shorted medium
  • Connector corroded or loose medium
  • Rail pressure sensor faulty internally medium
  • Engine control module low

Symptoms

  • Check engine light on
  • Limp mode or 'Reduced Engine Power'
  • Hard starting, stalling
  • Rough running

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0192

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication