P0190
Fuel Rail Pressure Sensor A Circuit
The rail pressure sensor A measures the pressure in the high-pressure fuel rail of common-rail diesels and petrol direct-injection engines – a three-wire sensor with 5 V reference. P0190 is the general circuit code used when a manufacturer does not split low and high; GM and Ford use P0192/P0193 instead. Bosch EDC16 diesels (Saab/Opel 1.9) report P0190 with a fault type byte, and a Saab bulletin traces it to corrosion in the sensor connector, sometimes with no restart for up to 15 minutes. On a sensor fault the engine runs on a calculated pressure in limp mode – on Saab's 3.0 V6 diesel with at most 40 MPa rail pressure and 20 % pedal.
Possible causes
- Connector corroded or water ingress at the rail pressure sensor high
- Rail pressure sensor faulty medium
- Harness damaged (heat, chafing) medium
- 5 V reference disturbed low
Symptoms
- Check engine light on
- Limp mode, loss of power
- Stalling or no start (sometimes only after a waiting time)
- Rough idle
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P0190
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- law.cornell.edu/regulations/california/13-CCR-1968.2
- saabwisonline.com/9-5-9600/2007/2-engine/fuel-system-petrol/bulletins-si-mi/234-2718-engine-running-poorly
- saabwisonline.com/9-5-9600/2003/2-engine/engine-management-system-v6-diesel/technical-description/fuel-pressure-sensor-fuel-rail
- fordservicecontent.com/Ford_Content/catalog/motorcraft/obd-summary-diesel-2023.pdf