OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P018C

Fuel Pressure Sensor B Circuit Low

Fuel pressure sensor B is a second fuel pressure sensor; which one is up to the manufacturer. On GM it is the low-pressure sensor in the supply line of direct-injection engines (0–743 kPa), read by the engine module or the fuel pump control module; on Ford engines with dual injection it is the sensor on the port-injection rail (0.5–4.5 V for about 0–70 psi). Sensor A is the high-pressure rail sensor (P0190–P0194). P018C means the signal voltage is below its lower limit – a signal wire shorted to ground, or an open signal or 5 V reference wire; a short on another sensor sharing the reference can also pull it down. GM sets it below 4 % of the reference (about 0.2 V), or below 0.14 V when the sensor is read by the fuel pump module, in 64 or 72 of 80 samples; two trips. Ford sets it below 0.049 V for 8 s. The control module then uses a fixed value or fixed pump control.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number1 / 8C

Possible causes

  • Signal wire shorted to ground or open high
  • 5 V reference missing or shorted (also by another sensor on the circuit) medium
  • Sensor faulty medium
  • Connector corroded medium

Symptoms

  • Check engine light on
  • Starting problems
  • Lack of power or stumbling
  • Sometimes no symptoms

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P018C

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication