OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P018B

Fuel Pressure Sensor B Circuit Range/Performance

Fuel pressure sensor B is a second fuel pressure sensor; which one is up to the manufacturer. On GM it is the low-pressure sensor in the supply line of direct-injection engines (0–743 kPa), read by the engine module or the fuel pump control module; on Ford engines with dual injection it is the sensor on the port-injection rail (0.5–4.5 V for about 0–70 psi). Sensor A is the high-pressure rail sensor (P0190–P0194). P018B is the plausibility fault. GM checks actively whether the sensor responds: if the pump duty sits at its limit for 5 s or the pressure error varies too little, the module changes pump output and fails the sensor if pressure moves 30 kPa or less – a 'frozen' sensor; two trips. Ford checks the deviation from target instead: more than 20 psi (about 1.4 bar) for 8 s with a plausible target of 35–60 psi, which can also be a genuine pressure problem. A fault-free P018B is a precondition for GM's pump output check (P2635) and Ford's supply checks (P008A/P008B).

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number1 / 8B

Possible causes

  • Sensor drifting or stuck (diaphragm, electronics) high
  • Genuine low-pressure fault: weak pump, clogged filter, faulty regulator medium
  • Contact resistance at connector or ground medium
  • Fuel pump control module or its control low

Symptoms

  • Check engine light on
  • Hard starting or hesitation when accelerating
  • Stumbling under load
  • Often no symptoms

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P018B

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication