OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P018A

Fuel Pressure Sensor B Circuit

Fuel pressure sensor B is a second fuel pressure sensor; which one is up to the manufacturer. On GM it is the low-pressure sensor in the supply line of direct-injection engines (0–743 kPa), read by the engine module or the fuel pump control module; on Ford engines with dual injection it is the sensor on the port-injection rail (0.5–4.5 V for about 0–70 psi). Sensor A is the high-pressure rail sensor (P0190–P0194). P018A is the general circuit fault for when a manufacturer does not distinguish low from high. GM and Ford, whose sensor B functions are documented, use P018C/P018D instead, so no manufacturer document using exactly this code was found; the description rests on CARB's circuit monitoring requirement and the component information. When the sensor fails, the control module uses a pre-set value and usually runs the supply pump with fixed control.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number1 / 8A

Possible causes

  • Connector corroded or loose, broken wire high
  • Sensor faulty medium
  • 5 V reference disturbed (shared with other sensors) medium
  • Engine or fuel pump control module, or CAN transmission low

Symptoms

  • Check engine light on
  • Often no noticeable change in driving
  • Starting problems or hesitation with fixed pump control

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P018A

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication