P0188
Fuel Temperature Sensor B Circuit High
Fuel temperature sensor B is an NTC thermistor: the hotter the fuel, the lower its resistance and signal voltage. On diesels it sits in the injection pump, rail or return line; on Ford petrol direct-injection engines it is built into the rail pressure sensor, and GM uses digital rail temperature sensors on its direct-injection engines. Sensor B is the second measuring point, for example GM's 6.6 litre diesel sensor 2 or a second rail. P0188 means the signal of sensor B is above its valid range – typically an open circuit or unplugged connector, so the module would read about −40 to −50 °C. GM's 6.6 litre diesel sets it above 4.75 V (below about −50 °C) for 5 s; on GM's direct-injection petrol engines the digital rail temperature sensor 2 sets it above a count of 1865, after two trips.
Possible causes
- Connector off or wire open high
- Sensor open internally high
- Sensor ground open or short to 5 V medium
- Engine control module low
Symptoms
- Check engine light on
- Fuel temperature about −40/−50 °C in scan data
- Usually no change in driving
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0188
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.