OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0184

Fuel Temperature Sensor A Circuit Intermittent

Fuel temperature sensor A is an NTC thermistor: the hotter the fuel, the lower its resistance and signal voltage. On diesels it sits in the injection pump, rail or return line; on Ford petrol direct-injection engines it is built into the rail pressure sensor, and GM uses digital rail temperature sensors on its direct-injection engines. P0184 covers jumps in the signal: fuel cannot heat up or cool down that fast, so a sudden change points to a loose contact. GM diesels check every new value against an exponentially filtered window around the last good value and set the code when 10 of 15 samples (100 ms each) fall outside; two trips, blocked while a circuit fault is active. GM still writes 'Circuit Intermittent' in 2016 and 2018 – a change to 'Intermittent/Erratic' is not documented. No source was found for petrol engines.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number1 / 84

Possible causes

  • Loose contact or weak terminal tension in the connector high
  • Wire break or chafing from vibration high
  • Sensor with internal dropouts medium
  • Corrosion from moisture medium

Symptoms

  • Check engine light on
  • Fuel temperature in scan data jumps
  • Usually no change in driving

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0184

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication