OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0181

Fuel Temperature Sensor A Circuit Range/Performance

Fuel temperature sensor A is an NTC thermistor: the hotter the fuel, the lower its resistance and signal voltage. On diesels it sits in the injection pump, rail or return line; on Ford petrol direct-injection engines it is built into the rail pressure sensor, and GM uses digital rail temperature sensors on its direct-injection engines. P0181 is the plausibility check: after a long standstill fuel temperature must be close to another temperature sensor. Ford's 2023 diesels compare it after 6 h with the charge air cooler outlet temperature (limit 40 °C, or 20 °C without a block heater); GM diesels compare it after 8 h with a reference sensor (20 °C, two trips). Bulletins show other causes: Ford may set P0181 during a running self-test with fuel below 10 °C and warns against replacing parts without a confirmed fault; Nissan Rogues set it because of misrouted wires at the pump unit; Ford's 2018 6.7 diesel needed new software.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number1 / 81

Possible causes

  • Sensor drifting (characteristic shifted) high
  • Comparison sensor wrong (charge air, coolant, intake air) medium
  • Block heater or unusual temperatures (cold fuel during self-test) medium
  • Wiring or connector (e.g. routing at the pump unit) medium
  • Control module software low

Symptoms

  • Check engine light on (often without change in driving)
  • Possibly harder cold or hot start
  • Diesel: less accurate rail pressure and quantity correction

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0181

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication