P0180
Fuel Temperature Sensor A Circuit
Fuel temperature sensor A is an NTC thermistor: the hotter the fuel, the lower its resistance and signal voltage. On diesels it sits in the injection pump, rail or return line; on Ford petrol direct-injection engines it is built into the rail pressure sensor, and GM uses digital rail temperature sensors on its direct-injection engines. P0180 is the general circuit fault without telling low from high. None of the manufacturers checked (GM, Ford, Saab/Bosch, Nissan) uses it – they report P0181–P0184 instead. No manufacturer document using exactly this code was found; the description rests on CARB's circuit monitoring requirement and component information. With a sensor fault the control module uses a substitute temperature (Saab EDC16: 50 °C).
Possible causes
- Wire or connector open or corroded high
- Sensor faulty high
- Control module reference or ground low
Symptoms
- Check engine light on
- Substitute value; possibly starting problems in cold or hot conditions
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0180
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.