OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P017C

Cylinder Head Temperature Sensor A Circuit Low

The cylinder head temperature sensor A is an NTC thermistor that measures the temperature of the cylinder head metal or of the coolant in the head. Some Ford engines use it instead of a coolant temperature sensor and calculate a coolant value from it; VW group V8 petrol engines use it as sender G407. CARB requires such sensors to be monitored like the coolant sensor. P017C means the signal voltage is too low – a short to ground of the signal wire or a short inside the sensor; the control module would read an implausibly hot cylinder head. 'Low' refers to the signal, not the temperature. Audi and Bentley document it as a short to ground, most often caused by water inside sender G407 after O-ring damage. Ford flags the same condition on its own code below 0.244 V for 5 s. A substitute value is used; an overheating warning with a cold engine is a typical sign.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number1 / 7C

Possible causes

  • Water or coolant inside the sensor (O-ring damaged) high
  • Signal wire chafed against ground medium
  • Sensor shorted internally medium
  • Engine control module low

Symptoms

  • Check engine light on
  • Overheating or coolant warning despite a cold engine
  • Radiator fan runs constantly

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P017C

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication