P0179
Fuel Composition Sensor Circuit High
The fuel composition sensor is fitted only to flex-fuel vehicles that can run on petrol or ethanol up to E85. GM uses a capacitive sensor in the fuel line whose square-wave output frequency gives the ethanol content – 50 Hz for E0 up to 150 Hz for E100 – while the pulse width carries the fuel temperature. Ford has calculated the ethanol content from the oxygen sensor feedback after refuelling since model year 2000 and has no such sensor. P0179 means the frequency is above the physically possible range for E100 plus tolerance. GM sets it between 155 and 185 Hz (50 of 63 samples, two trips); above 185 Hz it sets P2269 instead, because such a high value indicates water or conductive fuel rather than a sensor fault. Typical causes of P0179 are failed sensor electronics or interference on the signal wire. With a falsely high ethanol value the mixture tends to run rich.
Possible causes
- Sensor electronics faulty high
- Interference or short on the signal wire medium
- Water or conductive fuel near the P2269 limit medium
- Engine control module low
Symptoms
- Check engine light on
- Ethanol value implausibly high (100 %)
- Rich mixture, stumbling, higher consumption
Inspection / repair
- Difficulty: easy
- DIY: possible
What Pro shows you for P0179
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.