OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0178

Fuel Composition Sensor Circuit Low

The fuel composition sensor is fitted only to flex-fuel vehicles that can run on petrol or ethanol up to E85. GM uses a capacitive sensor in the fuel line whose square-wave output frequency gives the ethanol content – 50 Hz for E0 up to 150 Hz for E100 – while the pulse width carries the fuel temperature. Ford has calculated the ethanol content from the oxygen sensor feedback after refuelling since model year 2000 and has no such sensor. P0178 means the frequency is too low. GM sets it below 45 Hz with 50 of 63 samples failing at 100 ms intervals (about 6 s), monitored continuously with the powertrain relay above 11 V; two trips. 'Low' refers to the frequency, not to the ethanol content: an open wire, missing supply or short to ground gives 0 Hz. The control module then uses a learned or substitute ethanol value. GM's road-salt special coverage for 2013–2014 flex-fuel models concerns exactly this kind of electrical failure.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number1 / 78

Possible causes

  • Signal wire open or shorted to ground high
  • Sensor without supply (relay, fuse, ground) high
  • Sensor electrically failed (corrosion) high
  • Engine control module low

Symptoms

  • Check engine light on
  • Ethanol value 0 % or frozen
  • Starting problems on E85
  • GM: remote start disabled

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for P0178

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication