OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0172

System Too Rich Bank 1

With closed-loop control the engine module corrects the injected fuel using the oxygen sensor: short-term fuel trim reacts within fractions of a second, long-term trim stores a learned base correction per load and speed range. Positive values mean fuel is being added because the mixture was lean, negative values mean fuel is being removed; around ±10 % is normal. P0172 means long-term trim on bank 1 is at its lower limit: the module already removes the maximum fuel and the mixture still stays rich. GM separates purge influence carefully: before the first purge it evaluates passively (factor 0.70 or below, i.e. −30 %), afterwards it closes the purge valve briefly for an active test, so a full charcoal canister is not counted as a fault. Ford only evaluates with purge off, at −25 %. Two trips. Bulletins name an open purge valve, leaking direct injectors and, on flex-fuel vehicles, a wrongly learned ethanol content. A permanently rich mixture can overheat the converter and dilutes the oil.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number1 / 72

Possible causes

  • Purge valve stuck open or charcoal canister saturated high
  • Leaking or dripping injectors (also direct injection) medium
  • Fuel pressure too high (faulty regulator, blocked return, regulator vacuum hose) medium
  • Fuel in the engine oil (short trips, leaking injectors), vapour via crankcase ventilation medium
  • Clogged air filter or intake, air flow sensor reading high; flex-fuel: wrongly learned ethanol content low

Symptoms

  • Check engine light on (after two drive cycles)
  • Higher consumption, fuel smell
  • Black smoke, sooted spark plugs
  • Rough idle or starting problems after refuelling; converter damage possible later

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0172

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication