P0168
Fuel Temperature Too High
P0168 is not a sensor fault but an operating condition, almost only on diesels: the fuel temperature sensor reports fuel hotter than a protective limit. The fuel heats up through the return flow from the high-pressure pump and injectors, especially with little fuel in the tank, at idle after full load, in hot weather or with a failed fuel cooler; one manufacturer patent names about 80 °C as the upper limit to protect seals, against a normal range of roughly 5–60 °C. On Saab's Bosch EDC16 diesels the code means an engine protection function is active and injection quantity is reduced. No manufacturer threshold was found, and GM's and Ford's diesel summaries do not use P0168. Whether the warning light comes on depends on the manufacturer.
Possible causes
- Fuel cooler (air or water cooler in the return) dirty or faulty, coolant circuit disturbed high
- Very little fuel in the tank at high load or heat medium
- Excessive return flow from worn high-pressure pump or injectors, or faulty overflow valve medium
- Fuel temperature sensor drifting and reading too high medium
- Engine overheating or overload (trailer, gradient) low
Symptoms
- Loss of power, limp mode (reduced injection quantity)
- Warning light depending on manufacturer
- Occurs in heat, at full load, with little fuel in the tank
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0168
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.