OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0167

O2 Sensor Heater Circuit Bank 2 Sensor 3

Sensor 3 on bank 2 is a switching oxygen sensor behind a second converter or converter brick. It is rare – documented for Jaguar Land Rover's supercharged V6 and V8 (2013–2016), where it is the 'post-cat' sensor of the second bank, and for Ford systems that monitor part of the converter volume. P0167 concerns its heater. Ford checks the driver voltage continuously and the heater current once per drive cycle when the sensor is estimated above about 120 °C and has heated for 30 s; below 0.22–0.55 A (depending on sensor type) or above 3 A is a fault, and the heater resistance has its own code (P0061). Jaguar Land Rover lists P0167 for its post-cat sensor of the second bank. A cold sensor can lead to P0165/P0166. When it fails, the downstream evaluation of that converter is suspended; there is no limp mode.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number1 / 67

Possible causes

  • Heater element burnt out high
  • Heater wiring, connector or fuse medium
  • Short circuit (current above 3 A) low
  • Engine module driver or software (Jaguar Land Rover) low

Symptoms

  • Check engine light on (usually after two drive cycles)
  • P0165/P0166 may follow
  • Usually no noticeable change in driving

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for P0167

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication