OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0165

O2 Sensor Circuit Slow Response Bank 2 Sensor 3

Sensor 3 on bank 2 is a switching oxygen sensor behind a second converter or converter brick. It is rare – documented for Jaguar Land Rover's supercharged V6 and V8 (2013–2016), where it is the 'post-cat' sensor of the second bank, and for Ford systems that monitor part of the converter volume. P0165 means sensor 3 reacts too slowly to mixture changes, typically measured around fuel cut-off as for the downstream sensor 2 (Subaru limits for P0139: 0.51 s rich to lean, 2 s lean to rich). No manufacturer document using exactly this code was found – the Jaguar Land Rover bulletins list only P0162–P0164 and P0167 for this sensor. The description rests on CARB's response requirement for downstream sensors and the sensor 2 logic. When it fails, the downstream evaluation of that converter is suspended; there is no limp mode.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number1 / 65

Possible causes

  • Sensor aged or contaminated high
  • Sensor heater weak medium
  • Exhaust leak ahead of the sensor medium
  • Wiring or connector high-resistance low

Symptoms

  • Check engine light on (usually after two drive cycles)
  • Catalyst readiness incomplete
  • Usually no noticeable change in driving

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for P0165

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication