OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0163

O2 Sensor Circuit Low Voltage Bank 2 Sensor 3

Sensor 3 on bank 2 is a switching oxygen sensor behind a second converter or converter brick. It is rare – documented for Jaguar Land Rover's supercharged V6 and V8 (2013–2016), where it is the 'post-cat' sensor of the second bank, and for Ford systems that monitor part of the converter volume. P0163 means the signal stays close to 0 V – typically the signal wire is shorted to ground; on some modules an open circuit is also reported this way, and an exhaust leak ahead of the sensor can make it read lean. For the bank 2 sensor 2 counterpart GM uses below 50 mV within 50 s, Ford a pull-up resistance check (short below 10 Ω, open above 1 MΩ). Jaguar Land Rover assigns the code to that sensor and names software (fixed by reconfiguring the engine module) and water-induced thermal shock as causes; no thresholds are published for sensor 3, so the logic follows the sensor 2 checks. When it fails, the downstream evaluation of that converter is suspended; there is no limp mode.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number1 / 63

Possible causes

  • Signal wire shorted to ground (chafed or melted) high
  • Sensor faulty medium
  • Exhaust leak ahead of the sensor (apparently lean) medium
  • Engine module software (Jaguar Land Rover) low

Symptoms

  • Check engine light on (usually after two drive cycles)
  • Catalyst readiness incomplete
  • Usually no noticeable change in driving

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for P0163

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication