OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0160

O2 Sensor Circuit No Activity Detected Bank 2 Sensor 2

The oxygen sensor after the catalytic converter on bank 2 (sensor 2) is a switching sensor used for converter monitoring and downstream mixture trim; it exists only on V and boxer engines with a separate downstream sensor per bank. P0160 means the sensor shows no change in voltage although it is heated and the engine is in closed loop; the control module only sees its own bias voltage, so the circuit is open or high-resistance or the sensor is dead. On GM's 3.0/3.6 V6 the code sets within 15 s after more than 150 s of running; newer GM systems apply 1900 mV and treat above 1700 mV as open; two trips. Ford does not use P0160 and reports 'no activity' as P0156. A failed heater (P0161) can also cause it. The previous obdex title mixed in 'Slow Response', which is P0159. When it fails, the downstream evaluation of that converter is suspended; there is no limp mode.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number1 / 60

Possible causes

  • Signal or ground wire open or high-resistance, connector corroded high
  • Sensor dead, poisoned or damaged by thermal shock high
  • Heater failed or fuse blown by a heater short medium
  • Signal wire shorted to voltage low

Symptoms

  • Check engine light on (usually after two drive cycles)
  • Catalyst monitor readiness for bank 2 not set
  • Often with P0161 or P0157/P0158

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for P0160

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication