OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P015F

Excessive Time to Enter Closed Loop Cylinder Balance Control

Cylinder balance control evens out the contribution of individual cylinders – on diesels by adjusting each injector's quantity based on crankshaft speed fluctuations. P015F, by its title, is set when this closed-loop control does not become active within the expected time after starting, for example because the crankshaft wheel has not been learned or the conditions are missing. No manufacturer using P015F was found: Ford's 2023 diesels run cylinder balancing (maximum correction 3.5–15 mg per stroke) but report problems as P0263–P0284. The description therefore rests on CARB's requirement for feedback controls and that comparable function; causes are derived, not documented.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number1 / 5F

Possible causes

  • Crankshaft wheel adaptation not learned or speed signal disturbed medium
  • Injector deviating strongly or injector circuit fault medium
  • Control module software low

Symptoms

  • Check engine light on
  • Possibly rough idle
  • Often no symptoms

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P015F

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication