OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P015A

O2 Sensor Delayed Response - Rich to Lean Bank 1 Sensor 1

The upstream oxygen sensor (sensor 1, before the catalytic converter) is the main control sensor for the air-fuel mixture. 'Delayed response' means the sensor starts reacting too late, or does not reach the target level at all, after the mixture has changed. This code covers the rich-to-lean direction, usually tested during deceleration fuel cut-off. GM uses this on switching (narrow-band) sensors: while the fuel cut-off for the downstream tests is running, it measures how long the upstream sensor takes to start dropping from above 680 mV and fails a filtered delay above about 0.58 s after one trip. Conditions include warm engine, 40–78 mph and a hot converter. CARB requires separate detection of slow and delayed faults in each direction (phased in from 2009 for downstream and 2011 for upstream sensors).

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number1 / 5A

Possible causes

  • Upstream oxygen sensor aged or poisoned (silicone, oil, coolant, soot) high
  • Exhaust leak ahead of the sensor (manifold, flange) medium
  • Mixture fault: intake air leak, injectors, fuel pressure, air flow sensor low
  • Sensor heater weak, sensor too cold low
  • Connector, wiring or control module software low

Symptoms

  • Check engine light on
  • Slightly higher consumption or rough idle possible
  • Higher emissions, possible emissions test failure
  • Often no noticeable symptoms

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for P015A

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication