P0156
O2 Sensor Circuit Bank 2 Sensor 2
The oxygen sensor after the catalytic converter on bank 2 (sensor 2) is a switching sensor (about 0.1–0.9 V) used for converter monitoring and fine mixture trim. Bank 2 exists only on V and boxer engines with a separate downstream sensor per bank. P0156 is the bank 2 counterpart of P0136. Ford sets it as 'no activity' when the downstream sensor on bank 2 never swings outside a narrow band around 0.45 V in its functional check, if needed after forced mixture changes, once per drive cycle. Exhaust systems with a Y-pipe have only one downstream sensor, which counts as bank 1. When it fails, the control module stops the downstream trim and cannot evaluate the converter; there is no limp mode.
Possible causes
- Downstream sensor aged or poisoned (stays in the middle band) high
- Signal or ground wire open or high-resistance, connector corroded medium
- Sensor heater failed (sensor stays cold) medium
- Exhaust leak ahead of the sensor low
Symptoms
- Check engine light on (usually after two drive cycles)
- Catalyst monitor readiness not set
- Usually no noticeable change in driving
Inspection / repair
- Difficulty: easy
- DIY: possible
What Pro shows you for P0156
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.