OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0154

O2 Sensor Circuit No Activity Detected Bank 2 Sensor 1

The oxygen sensor before the catalytic converter on bank 2 (sensor 1) is the main control sensor for the mixture. It is either a switching sensor (about 0.1 V lean to 0.9 V rich) or a wide-band sensor that works with a pump current evaluated by an interface chip. Bank 2 exists only on engines with two exhaust manifolds. P0154 is the bank 2 counterpart of P0134: the sensor delivers no moving signal and the control module only sees its own bias voltage. On GM's 3.0/3.6 V6 the code is set when the signal stays at 350–550 mV after heater warm-up, within about 15 s, in closed loop after 150 s of running; two trips. Ford's Bosch wide-band systems have used P2240 instead since 2011. A failed heater (P0155) can also lead to this code. A stored code usually switches mixture control to open loop and suspends adaptation and converter monitoring.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number1 / 54

Possible causes

  • Open or high-resistance signal or ground wire, connector loose or corroded high
  • Sensor faulty (cell high-resistance, worn out) high
  • Sensor heater faulty – sensor does not get hot enough medium
  • Control module bias or measuring circuit faulty low

Symptoms

  • Check engine light on
  • No mixture control (open loop), higher consumption
  • Higher emissions, possible emissions test failure

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0154

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication