OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0153

O2 Sensor Circuit Slow Response Bank 2 Sensor 1

The oxygen sensor before the catalytic converter on bank 2 (sensor 1) is the main control sensor for the mixture. It is either a switching sensor (about 0.1 V lean to 0.9 V rich) or a wide-band sensor that works with a pump current evaluated by an interface chip. Bank 2 exists only on engines with two exhaust manifolds. P0153 is the bank 2 counterpart of P0133: the sensor reacts too slowly to mixture changes. GM measures passively the average response time in both directions across 300/400–600 mV over 60 s and also fails too few transitions; Ford modulates the mixture itself and evaluates amplitude, signal line length or response times. The test runs once per drive at warm part load, two trips. The previous obdex title of this code wrongly repeated P0152's 'High Voltage'.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number1 / 53

Possible causes

  • Aged, sooted or poisoned upstream sensor (oil, silicone, coolant, additives) high
  • Exhaust leak ahead of the sensor (manifold gasket, crack) medium
  • Sensor heater weak or intermittent (sensor too cold) medium
  • Mixture fault: air leak, injectors, fuel pressure, air flow sensor medium
  • Wiring resistance or aftermarket sensor with different characteristics low

Symptoms

  • Check engine light on (after two drive cycles)
  • Slightly higher consumption
  • Higher emissions, possible emissions test failure
  • P0430 may follow

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0153

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication