OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0152

O2 Sensor Circuit High Voltage Bank 2 Sensor 1

The oxygen sensor before the catalytic converter on bank 2 (sensor 1) is the main control sensor for the mixture. It is either a switching sensor (about 0.1 V lean to 0.9 V rich) or a wide-band sensor that works with a pump current evaluated by an interface chip. Bank 2 exists only on engines with two exhaust manifolds. P0152 is the bank 2 counterpart of P0132. Switching sensors: GM above 1050 mV (100 of 125 samples, after warm-up), Ford above 1.1 V for 10 s – a reading the sensor cannot produce itself, so heater or battery voltage on the signal wire is the usual cause; GM also reads an open wire as high. Wide-band sensors: a sensor wire shorted to voltage. P0152 together with P0158 points to a shared short in the bank 2 harness. Two trips. A stored code usually switches mixture control to open loop and suspends adaptation and converter monitoring.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number1 / 52

Possible causes

  • Signal wire shorted to the heater supply or battery voltage (melted or chafed harness) high
  • Sensor faulty internally (heater-to-signal short) high
  • Open or high-resistance signal or ground wire (GM reads its bias voltage) medium
  • Sensor contaminated by silicone, coolant or oil low

Symptoms

  • Check engine light on
  • Higher consumption, possibly rough running (no mixture control)
  • Higher CO/HC values
  • Often with P0158 or P0155

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0152

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication