OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0150

O2 Sensor Circuit Bank 2 Sensor 1

The oxygen sensor before the catalytic converter on bank 2 (sensor 1) is the main control sensor for the mixture. It is either a switching sensor (about 0.1 V lean to 0.9 V rich) or a wide-band sensor that works with a pump current evaluated by an interface chip. Bank 2 exists only on engines with two exhaust manifolds. P0150 is the bank 2 counterpart of P0130. Ford used it up to 2010 as the collective code for wiring faults of the bank 2 wide-band sensor reported by the interface chip and has used specific codes since 2011 (P0151, P0152, P2240/P2247/P2254). Other makers fill it as for bank 1 – an interface voltage check, a collective code or a plausibility test. No bank 2-specific manufacturer thresholds were found. If P0130 and P0150 appear together, look for a shared cause such as supply, ground or the control module. A stored code usually switches mixture control to open loop and suspends adaptation and converter monitoring.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number1 / 50

Possible causes

  • Wiring or connector of the bank 2 upstream sensor damaged, corroded or wet high
  • Oxygen sensor faulty internally high
  • Exhaust leak ahead of the sensor or mixture fault (plausibility versions) medium
  • Control module or sensor interface chip faulty low

Symptoms

  • Check engine light on
  • Higher consumption, possibly rough running (no mixture control)
  • Higher emissions, possible emissions test failure

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0150

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication