P014F
O2 Sensor Slow Response - Lean to Rich Bank 2 Sensor 1
The upstream oxygen sensor (sensor 1, before the catalytic converter) is the main control sensor for the air-fuel mixture. 'Slow response' means the signal transition itself is too sluggish – it takes too long to pass between two voltage levels. This code covers the lean-to-rich direction, tested when fuel returns or the control module briefly enriches the mixture. Bank 2 only exists on V and boxer engines. No manufacturer document using exactly this code was found; the description rests on CARB and on the published principle of testing an upstream sensor by periodic mixture modulation, where a sensor time constant above a load-dependent limit counts as a fault. CARB requires separate detection of slow and delayed faults in each direction (phased in from 2009 for downstream and 2011 for upstream sensors).
Possible causes
- Upstream oxygen sensor aged or poisoned (silicone, oil, coolant, soot) high
- Exhaust leak ahead of the sensor (manifold, flange) medium
- Mixture fault: intake air leak, injectors, fuel pressure, air flow sensor low
- Sensor heater weak, sensor too cold low
- Connector, wiring or control module software low
Symptoms
- Check engine light on
- Slightly higher consumption or rough idle possible
- Higher emissions, possible emissions test failure
- Often no noticeable symptoms
Inspection / repair
- Difficulty: easy
- DIY: possible
What Pro shows you for P014F
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.