OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P014E

O2 Sensor Slow Response - Rich to Lean Bank 2 Sensor 1

The upstream oxygen sensor (sensor 1, before the catalytic converter) is the main control sensor for the air-fuel mixture. 'Slow response' means the signal transition itself is too sluggish – it takes too long to pass between two voltage levels. This code covers the rich-to-lean direction, usually tested during deceleration fuel cut-off. Bank 2 only exists on V and boxer engines. No manufacturer document using exactly this code was found. The principle is known from wide-band sensor tests: the control module modulates the mixture and evaluates the sensor's response time in each direction (Ford, Siemens patent) – Ford, however, reports such faults for bank 2 as P0153. CARB requires separate detection of slow and delayed faults in each direction (phased in from 2009 for downstream and 2011 for upstream sensors).

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number1 / 4E

Possible causes

  • Upstream oxygen sensor aged or poisoned (silicone, oil, coolant, soot) high
  • Exhaust leak ahead of the sensor (manifold, flange) medium
  • Mixture fault: intake air leak, injectors, fuel pressure, air flow sensor low
  • Sensor heater weak, sensor too cold low
  • Connector, wiring or control module software low

Symptoms

  • Check engine light on
  • Slightly higher consumption or rough idle possible
  • Higher emissions, possible emissions test failure
  • Often no noticeable symptoms

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for P014E

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication