OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P014C

O2 Sensor Slow Response - Rich to Lean Bank 1 Sensor 1

The upstream oxygen sensor (sensor 1, before the catalytic converter) is the main control sensor for the air-fuel mixture. 'Slow response' means the signal transition itself is too sluggish – it takes too long to pass between two voltage levels. This code covers the rich-to-lean direction, usually tested during deceleration fuel cut-off. Manufacturer documentation was found only for diesels: GM evaluates the oxygen signal of the NOx sensor when the engine goes from load to overrun and fails it above about 1.1 s (two trips); Ram lists it as soot-related. GM petrol engines use P015A/P015B instead, and Ford reported upstream response faults as P0133 in 2012. CARB requires separate detection of slow and delayed faults in each direction (phased in from 2009 for downstream and 2011 for upstream sensors).

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number1 / 4C

Possible causes

  • Upstream oxygen sensor aged or poisoned (silicone, oil, coolant, soot) high
  • Exhaust leak ahead of the sensor (manifold, flange) medium
  • Mixture fault: intake air leak, injectors, fuel pressure, air flow sensor low
  • Sensor heater weak, sensor too cold low
  • Connector, wiring or control module software low

Symptoms

  • Check engine light on
  • Slightly higher consumption or rough idle possible
  • Higher emissions, possible emissions test failure
  • Often no noticeable symptoms

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for P014C

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication