OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0148

Fuel Delivery Error

P0148 is an early, rather unspecific OBD II code: the control module finds that the fuel delivered does not match what was requested. Saab's 3.0 V6 diesel (Isuzu) uses it for leak detection: from the balance of quantity and rail pressure it recognises a leak of 90 mm³ per crankshaft revolution, monitored continuously up to 6,400 rpm, and then shuts the engine off – a restart is only possible in the next drive cycle. Ford lists P0148 in the fuel monitor of its 2020–2023 petrol engines, alongside P0171/P0172, without describing the logic. Newer systems usually report such faults more precisely as P0087/P0088 (rail pressure) or P0093 (large leak).

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number1 / 48

Possible causes

  • Fuel leak in the high-pressure or return section (line, rail, injector leakage) high
  • Fuel filter clogged or lift pump weak medium
  • High-pressure or injection pump worn medium
  • Pressure or volume control valve faulty low
  • Air in the fuel system (tank run dry) low

Symptoms

  • Check engine light on
  • Engine stalls or will not restart (Saab: shut-off until next drive cycle)
  • Loss of power, stumbling
  • Fuel smell with an external leak

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P0148

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication