OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0147

O2 Sensor Heater Circuit Bank 1 Sensor 3

Sensor 3 is a third oxygen sensor on bank 1, behind a second converter or converter brick. It only exists on some vehicles – documented for Jaguar Land Rover's 3.0 V6 supercharged (2013–2016, where sensor 2 is 'mid-cat' and sensor 3 'post-cat') and Ford systems that monitor part of the converter volume. P0147 concerns its heater. Ford checks the driver voltage continuously and the heater current once per drive cycle once sensor 3 is above about 120 °C and has heated for 30 s – below about 0.22–0.465 A (depending on supplier) or above 3 A counts as a fault; the heater resistance is a separate code (P0055). Jaguar Land Rover lists P0147 for its post-cat sensor. When it fails, the control module stops the downstream trim and cannot evaluate the converter; there is no limp mode.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number1 / 47

Possible causes

  • Heater element in the sensor burnt out (replace sensor) high
  • Heater supply (fuse, relay) or control wire open medium
  • Connector corroded, contact resistance low

Symptoms

  • Check engine light on (usually after two drive cycles)
  • Follow-up codes for sensor 3 possible
  • Usually no noticeable change in driving

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for P0147

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication