P0146
O2 Sensor Circuit No Activity Detected Bank 1 Sensor 3
Sensor 3 is a third oxygen sensor on bank 1, behind a second converter or converter brick. It only exists on some vehicles – documented for Jaguar Land Rover's 3.0 V6 supercharged (2013–2016, where sensor 2 is 'mid-cat' and sensor 3 'post-cat') and Ford systems that monitor part of the converter volume. P0146 means sensor 3 produces no voltage of its own and only the control module's bias voltage is seen, as for sensor 2 (P0140): GM evaluates a signal stuck in the 401–548 mV band, a high internal resistance or, with 1900 mV bias, an open circuit. No manufacturer document using exactly this code was found; Jaguar Land Rover lists only P0142–P0144 and P0147 for its sensor 3. When it fails, the control module stops the downstream trim and cannot evaluate the converter; there is no limp mode.
Possible causes
- Signal or ground wire open, connector off or corroded high
- Sensor heater failed, sensor never becomes active medium
- Sensor worn out (no longer produces voltage) medium
Symptoms
- Check engine light on (usually after two drive cycles)
- Usually no noticeable change in driving
Inspection / repair
- Difficulty: easy
- DIY: possible
What Pro shows you for P0146
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.