OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P013C

O2 Sensor Slow Response - Rich to Lean Bank 2 Sensor 2

The downstream oxygen sensor (sensor 2, after the catalytic converter) is used for fine mixture trim and to monitor the converter. 'Slow response' means the signal transition itself is too sluggish – it takes too long to pass between two voltage levels. This code covers the rich-to-lean direction, usually tested during deceleration fuel cut-off. Bank 2 only exists on V and boxer engines. GM forces the test itself and measures how quickly the signal passes from 450 to 150 mV relative to air flow; a filtered value above its limit sets the code after one trip (fallback: target not reached before about 70 g of air). Ford reports the same slew-rate test for bank 2 under this code. CARB requires separate detection of slow and delayed faults in each direction (phased in from 2009 for downstream and 2011 for upstream sensors).

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number1 / 3C

Possible causes

  • Downstream oxygen sensor aged or contaminated (soot, oil, silicone, coolant) high
  • Exhaust leak between manifold/turbo and the sensor medium
  • Converter faulty or non-original with different oxygen storage low
  • Control module software too sensitive (update available) low
  • Sensor connector or wiring with contact resistance low

Symptoms

  • Check engine light on
  • Usually no noticeable change in driving
  • Catalyst monitor may stay incomplete (inspection readiness missing)
  • With a converter cause, P0420/P0430 may follow

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for P013C

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication