OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0136

O2 Sensor Circuit Bank 1 Sensor 2

The oxygen sensor after the catalytic converter on bank 1 (sensor 2) is a switching sensor (about 0.1–0.9 V) used for converter monitoring and fine mixture trim. P0136 is the general circuit code, and its exact meaning varies by manufacturer. Ford sets it as 'no activity' in a functional check: if the sensor never swings beyond about 0.42/0.48 V despite rich and lean phases – if needed after forced enrichment and leaning – once per drive cycle. Opel/GM Europe set it if the average voltage stays outside 400–500 mV after 10 min of closed loop; older Bosch Motronic if it stays at 0 V for 200 s despite heating. GM North America does not use P0136. When it fails, the control module stops the downstream trim and cannot evaluate the converter; there is no limp mode.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number1 / 36

Possible causes

  • Downstream sensor aged or poisoned (stays in the middle band) high
  • Signal or ground wire open or high-resistance, connector corroded medium
  • Sensor heater failed (sensor stays cold) medium
  • Exhaust leak ahead of the sensor low
  • Control module or software low

Symptoms

  • Check engine light on (usually after two drive cycles)
  • Catalyst monitor readiness not set
  • Slightly higher consumption possible without downstream trim

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for P0136

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication