OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0133

O2 Sensor Circuit Slow Response Bank 1 Sensor 1

The oxygen sensor before the catalytic converter on bank 1 (sensor 1) is the main control sensor for the mixture. It is either a switching sensor (about 0.1 V lean to 0.9 V rich) or a wide-band sensor that works with a pump current evaluated by an interface chip. P0133 means the sensor does not react fast enough to mixture changes. Methods differ fundamentally: GM measures passively how long the signal takes to cross 400–600 mV in each direction, averaged over 60 s; Ford forces the mixture to swing at 1.5 Hz and fails a switching sensor whose amplitude stays below 0.5 V, or evaluates response times of a wide-band sensor against a no-fault area; Subaru compares controller activity with measured lambda over 210 s. The test runs once per drive at warm part load; two trips. Mixture control usually stays active, but worse.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number1 / 33

Possible causes

  • Aged, sooted or poisoned upstream sensor (oil, silicone, coolant, additives) high
  • Exhaust leak ahead of the sensor (manifold gasket, crack) medium
  • Sensor heater weak or intermittent (sensor too cold) medium
  • Mixture fault: air leak, injectors, fuel pressure, air flow sensor medium
  • Wiring resistance or aftermarket sensor with different characteristics low

Symptoms

  • Check engine light on (after two drive cycles)
  • Slightly higher consumption
  • Higher emissions, possible emissions test failure
  • P0420 may follow

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for P0133

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication