OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0132

O2 Sensor Circuit High Voltage Bank 1 Sensor 1

The oxygen sensor before the catalytic converter on bank 1 (sensor 1) is the main control sensor for the mixture. It is either a switching sensor (about 0.1 V lean to 0.9 V rich) or a wide-band sensor that works with a pump current evaluated by an interface chip. On switching sensors the signal is above what the sensor can physically produce (about 1 V): Ford above 1.1 V for 10 s, GM above 1050 mV, Saab Trionic above 1.5 V for 5 s. The cause is almost always electrical – the heater supply or battery voltage on the signal wire, or a heater-to-signal short inside the sensor; some GM modules also read an open wire this way. On wide-band sensors the interface chip reports a sensor wire shorted to voltage. If P0132 and P0138 appear together, a shared short in the harness is likely. A stored code usually switches mixture control to open loop and suspends adaptation and converter monitoring.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number1 / 32

Possible causes

  • Signal wire shorted to the heater supply or battery voltage (melted or chafed harness) high
  • Sensor faulty internally (heater-to-signal short) high
  • Open or high-resistance signal or ground wire (GM reads its bias voltage) medium
  • Moisture or corrosion in the connector medium
  • Sensor contaminated by silicone, coolant or oil low

Symptoms

  • Check engine light on
  • Higher consumption, possibly soot or fuel smell
  • Higher emissions, possible emissions test failure
  • Often with P0138 or heater codes

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0132

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication