OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P012D

Turbocharger/Supercharger Inlet Pressure Sensor A Circuit High

The turbocharger/supercharger inlet pressure sensor A sits ahead of the compressor – between air filter and turbocharger, or on GM's supercharged V8 between throttle and supercharger. It is an analogue 5 V pressure sensor used for the compressor pressure ratio, filter restriction and cross-checks with the other pressure sensors. P012D means the signal voltage is above its upper limit – typically the signal wire shorted to the 5 V reference or battery voltage, or an open sensor ground that lets the signal rise to the reference. GM's supercharged LT4/LT5 sets it above 97 % of the reference (about 124 kPa) with 320 of 400 samples failing, monitored continuously; two trips on the LT4, one on the 2019 LT5. FCA documented false settings on the 2019 Jeep Wrangler 2.0 turbo, fixed by new engine software. The control module substitutes a modelled or ambient value and may limit boost.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number1 / 2D

Possible causes

  • Signal wire shorted to 5 V reference or battery voltage high
  • Sensor ground open or connector corroded medium
  • Sensor faulty internally medium
  • Control module software (false setting) low

Symptoms

  • Check engine light on
  • Reduced power or limp mode possible
  • Often no noticeable symptoms

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P012D

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication