OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P012B

Turbocharger/Supercharger Inlet Pressure Sensor A Circuit Range/Performance

The turbocharger/supercharger inlet pressure sensor A sits between the air filter and the compressor. The engine uses it for the compressor pressure ratio, to judge air filter restriction (ambient minus inlet pressure) and to cross-check the other pressure sensors. P012B is a plausibility fault: the signal is electrically valid but stuck or offset. On GM's supercharged 6.2 V8 the sensor must read 50–115 kPa and agree within 10 kPa with MAP and ambient pressure after the engine has been off for more than 8 s; while running, it is compared with modelled values (fault above about 25–30 kPa). GM normally needs two trips, one in some 2019 applications. In operation inlet pressure is slightly below ambient because of filter losses, so a clogged filter or blocked intake lowers it further.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number1 / 2B

Possible causes

  • Sensor oiled (crankcase vent often joins before the compressor) or drifted high
  • Air filter heavily clogged or intake blocked or collapsed medium
  • Leak in the intake pipe between filter and compressor or at the sensor flange medium
  • High resistance in the wiring medium
  • Comparison sensor (MAP, baro, MAF) wrong or software low

Symptoms

  • Check engine light on
  • Loss of power or boost limitation
  • Possibly no noticeable symptoms

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for P012B

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication