P0129
Barometric Pressure Too Low
The engine control module needs the ambient air pressure for mixture, altitude correction and boost limits. It comes either from a dedicated barometric sensor or from the MAP sensor, read at key-on with the engine stopped and updated at wide-open throttle. P0129 means this value is lower than physically possible – even on the highest drivable passes air pressure stays around 50 kPa, and GM and Ford use 50 kPa as their lower plausibility limit. Usual causes are a MAP or baro sensor reading too low, a blocked sensor port or high resistance in the wiring. No manufacturer document naming exactly this code was found: GM and Ford file the same finding under P2227.
Possible causes
- MAP or baro sensor reading too low (dirty, oiled, drifted) high
- High resistance or corrosion in signal wire or connector medium
- Sensor port or hose blocked medium
- Control module (baro sensor often built in) or software low
Symptoms
- Check engine light on
- Rich mixture, higher consumption, rough idle
- Loss of power (altitude-corrected boost limits)
Inspection / repair
- Difficulty: easy
- DIY: possible
What Pro shows you for P0129
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.