OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0127

Intake Air Temperature Too High

P0127 is not a circuit fault but a functional check of the air path: the measured intake air temperature is too high for the operating state. The logic is documented for a Bosch EDC16 diesel (Saab 9-3): if the intake air exceeds 130 °C and does not fall below it within 45 s after the exhaust gas recirculation valve is closed, hot exhaust gas is evidently still entering or the sensor is wrong. The engine then disables EGR and runs in limp mode with reduced torque. GM has the code in its diesel software but disabled for US OBD II; Ford reports an overly hot intake air reading as P0111 instead. On other engines a hot reading can also come from warm under-bonnet air being drawn in.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number1 / 27

Possible causes

  • EGR valve stuck open or not sealing (diesel) high
  • EGR cooler clogged or bypass flap stuck in bypass medium
  • Charge air cooler dirty or airflow through it blocked medium
  • Sensor reading wrong, or hot engine-bay air drawn in (loose intake duct) medium

Symptoms

  • Check engine light on
  • Loss of power, limp mode with torque limit
  • EGR switched off
  • Knock tendency and retarded ignition on petrol engines

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0127

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication