OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0123

Throttle/Pedal Position Sensor/Switch A Circuit High

Sensor A is, in practice, throttle position sensor 1 at the throttle body; the accelerator pedal has its own codes (P2120 onwards). With a cable-operated throttle there is a single potentiometer (about 0.5 V closed to 4.5 V wide open). Electronic throttles have two sensors sharing a 5 V reference and ground, usually running in opposite directions – on GM throttle sensor 1 falls from 3–4 V at idle to below 1 V at full throttle. P0123 means the signal voltage of sensor A is above its upper limit – usually an open sensor ground, which lets the signal float up to the reference, or a signal wire shorted to 5 V or 12 V. Limits: Ford above 4.75 V (within 1 s), Saab/GM 2011 above 4.8 V for 1 s, Saab cable system above 4.96 V for 5 s. Because GM's sensor 1 runs inverted, a high signal there electrically resembles idle, not full throttle. GM sets it after one trip; electronic throttles go into limp mode.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number1 / 23

Possible causes

  • Sensor ground (low reference) open or high-resistance high
  • Signal wire shorted to 5 V or 12 V medium
  • Sensor or throttle body faulty medium
  • Moisture or corrosion in the connector medium

Symptoms

  • Check engine light, on electronic throttles also wrench lamp
  • Limp mode with reduced power ('Reduced Engine Power') on electronic throttles
  • Raised idle or delayed throttle response
  • Shift problems on automatics

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0123

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication