OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0122

Throttle/Pedal Position Sensor/Switch A Circuit Low

Sensor A is, in practice, throttle position sensor 1 at the throttle body; the accelerator pedal has its own codes (P2120 onwards). With a cable-operated throttle there is a single potentiometer (about 0.5 V closed to 4.5 V wide open). Electronic throttles have two sensors sharing a 5 V reference and ground, usually running in opposite directions – on GM throttle sensor 1 falls from 3–4 V at idle to below 1 V at full throttle. P0122 means the signal voltage of sensor A is below its lower limit – electrically meant, not 'throttle closed': typically an open or grounded signal wire or a missing 5 V reference. Limits: Ford below 0.25 V (detected within 1 s), Saab/GM 2011 below 0.3 V for 1 s, Saab cable system below 0.2 V for 5 s. GM treats it as a one-trip fault and switches to reduced engine power; Ford lights the MIL and wrench lamp and continues on the remaining sensor or in limp mode.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number1 / 22

Possible causes

  • Signal wire open or shorted to ground high
  • Connector at the throttle body loose or corroded high
  • 5 V reference missing (open, or shorted by another sensor) medium
  • Sensor or throttle body faulty medium
  • Engine control module faulty low

Symptoms

  • Check engine light, on electronic throttles also wrench lamp
  • Limp mode with reduced power ('Reduced Engine Power') on electronic throttles
  • Engine barely responds to the pedal or stalls at idle
  • High idle, A/C switched off (cable systems)

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0122

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication