P011D
Charge Air Cooler Temperature/Intake Air Temperature Correlation Bank 2
This is the bank 2 counterpart of P011C and only exists on engines with two separate intake paths, each with its own charge air cooler temperature sensor and intake air temperature sensor – for example V engines with twin turbochargers and separate charge air coolers. After a long standstill both bank 2 sensors should read nearly the same; if they disagree at start-up, without either showing a circuit fault, P011D is set. The code does not identify which sensor is wrong. No manufacturer document using exactly this code was found; the check follows the same principle Ford uses for bank 1 after 6 hours, with a preheater suspending it.
Possible causes
- Bank 2 charge air cooler temperature sensor drifting, oily or stuck high
- Bank 2 intake air temperature sensor drifting medium
- Contact resistance at connector or ground medium
- Undetected preheating or uneven cooling low
Symptoms
- Check engine light on
- Usually no change in driving
- Code often returns only after an overnight soak
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P011D
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.