OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0113

Intake Air Temperature Sensor 1 Circuit High Bank 1

Intake air temperature sensor 1 is the first air temperature sensor in the intake path; depending on the vehicle it is built into the mass air flow sensor, mounted near the air filter or, on some naturally aspirated GM engines, fitted in the intake manifold. Most versions are NTC thermistors in a 5 V divider: the hotter the air, the lower the signal voltage. P0113 means the signal is above its valid range. With an NTC sensor that is typically an open circuit – connector off, broken wire, open sensor or missing ground – or a short to a voltage source, and the module would read an extremely cold value (GM about −60 °C). Documented limits: Ford petrol above 4.96 V for 5 s, Ford diesel above 4.91 V, GM above about 127 kilohms. A classic cause is a sensor left unplugged after an air filter change; one manufacturer bulletin describes broken wires at the connector caused by harness tension. Monitoring is continuous, GM needs two trips.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number1 / 13

Possible causes

  • Connector unplugged or loose, or wire broken high
  • Sensor open internally high
  • Sensor return (ground) wire open medium
  • Signal wire shorted to a voltage source low
  • Engine control module faulty low

Symptoms

  • Check engine light on
  • Usually hardly noticeable
  • Slightly richer mixture and higher consumption possible
  • Torque limitation on some systems

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for P0113

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication